Hi Matt - back on this - I have an extremely good welder/fabricator I have started working with. Would it be possible to shorten the air tank to make the step for flush?

have you upgraded your door speakers at all?

hmm yea the init i have is powered now and does the same still so quiet, i have the preoiuts from the headunit set to 4v i will drop to 2v and see if it changes although it wont go as loud...

I’m just trying to work out how good the sub actually is and if I’m expecting too much - does your setup shake the car or is it a little more subtle bass to complement the speakers?

Hi Matt - any chance you can let me know the above? Trying to work out if I have a problem or it’s just that way

Hi Matt, I have done this and I put on a low level line amplifier as well but the bass is still pretty quiet, how is yours? Does it shake they car or is it very subtle?

Hi Matt - would the cornering modules from the 06-09 not allow the cornering lights? Also if I had an 06-09 (I don’t) that was adaptive would I lose this functionality from what you are saying?

Would you get one of these and 4 male rca connectors just in case? Guessing you mean this https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.co.uk%2Fulk%2Fitm%2F322928378672

It will be a line level that goes into the input of the Lear. Non dsp amp so full range do you think it will work ?

Any thoughts - will I need some kind of crossover or should we be good?

hey matt ready to go but its just dawned on me i will be handing the small amp a full range signal directly from the stereo… does the amp handle the crossing over or won’t that work?

you were correct i now need one pdc plug as one was badly corroded and wont work

Hi Matt - sorry I mean the side skirt trim. eBay item 132496864331 My thought is to buy a used one cut it in half longways and use the bit that the step would sit into

do you know if the master loom connector owuld be the same that joins all 4 to the car?

Should have said I have got Hk mids and tweeters in the front as well sound great

Any thoughts on this?

Hi Matt, No not meaning that on the passenger side the step sits under a black plastic trim which wraps around at the end. I wanted to move that down and insert a block of metal say 15mm thick and then put the bolts through that so technically it would be stronger but wasn’t sure if that trim came off easily

Also is the sun roof slider leather? The linings I’ve seen don’t seem to come with it?

Yea that’s right

Hi Grainsley - this is not too hard if you have the correct tools. From experience don't buy the oil from euro or eBay that is red - I did this and it started behaving like a massive jerk - get the expensive stuff - https://www.ebay.co.uk/itm/262907464642 That's what you need and from memory it needs around 11 litres.. What I did is warmed her up for ten minutes then took the bottom drain plug out with a hex tool so it ran nice and easy. Next you need to get a pump of some kind, put the bung back in and open the top one (on the side)... fills it up until it starts weeping out the. This is the most important thing... start it with the bung out, with your foot on the brake run it through every gear in Manual mode , drove , reverse etc... and with it still running pump some more oil in... there will be room now! Once it weeps again put the bung in and you should be done... You also may want to consider doing the filter - slightly harder but not too hard - from memory you drop the oil pan maybe 16 bolts or so once you have drained her and the there on or two bolts holding in the filler - take them out it will pull down and then do the same in reverse... Cheers!